Thrust Ball Bearings The Key Point Of Assembly

Thrust Ball Bearings The key point of assembly

Thrust ball bearing assembly has two key points

Thrust ball bearing assembly has two key points. One is the control of the quality of the cage with the ball, and the other is the control of the nominal height T after assembly. In addition, due to the shaft ring, seat can be separated, bringing a management problem. Is to prevent imported bearings parts mixed.

M-type stamping cage using crimping die. After pressing the steel ball in the pocket to turn flexible, but can not fall off from the pocket, and technical procedures to check the ball in the pocket hole in the amount of movement. Solid cage pressing pressure is too deep will make the ball ball movement is small, and the embossed convex part of the connection with the cage is too small and insufficient strength, prone to block the phenomenon, causing the cage to scrapped.

Small thrust ball bearing seat ring and shaft diameter diameter difference is very small, there is no significant difference between the two groups. In order to prevent the emergence of mixed sets of phenomena, that is loaded into a set of bearings Tao Tao sets are trapped or are the axis of the situation. This requires some action. Usually with the help of auxiliary tooling will be zoning, seat group to distinguish, or in the sampling of the nominal height before the diameter check with the diameter of the inner diameter, in order to check the inner diameter is convenient, put the seat down, the shaft placed above.

If the seat diameter has a significant quenching and heating oxidation or no grinding, there is no need to test the inner diameter, can clearly see the difference between the shaft and the seat, not easy to mix. Thrust ball bearings need to be assembled after the nominal height T to be measured, confirmed that the lilies. Measurement, with a high degree of block or standard difficult to calibrate, and to measure the load, the bearing should be rotated ten times, be sure to reach the minimum height.

When the thrust ball bearing in high-speed operation, the ball and raceway radial plane of the contact angle will be affected by centrifugal force, causing the ball relative to the raceway sliding. This sticking wear causes damage to the bearing. To prevent this damage, must ensure that the thrust ball bearing by the minimum load, see formula 1 or formula 2, take the larger calculation. Thrust ball bearings are supported by axial load roller bearings and their nominal contact angles greater than 45 degrees, the basic parts of the shaft and the race ring and the rolling body with or without cage.


Special flat bearing raceway ultra-fine technology to improve bearing performance. The use of high-speed hot forging forming process to improve the utilization of materials 18%, with low noise, long life of the thrust ball bearings. The new technology of the hydrogenated cage surface, an increase of 64% tensile strength in the cage.

The main purposeī¸°

Elevator accessories / plastic machinery

Office equipment, medical equipment

Stepper motor / reduction gear device

Pressure rotor / fitness and sports equipment.

Plane Thrust Ball Bearings You should now have a better understanding.